Hello,
Brand new user here. I have a lot of experience with other inspection platforms though so hopefully I will be able to pick this up quickly :)
I have a slot feature - ID 2 Cylinders and to planes that I need to create as a datum feature for other evaluation. I have tried the feature creation tool in the tool bar menu as well as the interactive option from the measure menu. Neither successfully gives me a slot feature that I can identify as Datum A.
Any direction on what I might be doing wrong?
Thanks,
Coleman
1. You can create a circle from intersection of cylinder and the plan.
2. Then use anchor to create the slot from the circles.
Perhaps I'm missing something here, but why don't you just create a slot feature?
Well the problem is my slot is the Primary datum in my control frame for another profile. The slot itself has a profile tolerance without control frame that constrains size and form only. I have another surface profile on a free form feature of size constrained to datum A (the slot) @MMB. This means My datum feature allows pattern shift as the surface of the slot deviates from the MMC condition as defined by the best fit profile tolerance. Additionally if I use the slot feature i loose the degrees of freedom controlled by the axis of my slot AND the feature is not being evalueated 3 dimensionally.