Print Page - Intersection point(s) between 2 cross-sections

Title: Intersection point(s) between 2 cross-sections
Post by: VDK on April 20, 2012, 01:02:20 AM

Hello,

I have made 2 cross-sections in a 3D mesh (scanned part), e.g. section #1 at Y=100 and section #2 at Z=80
Do someone know a method to create intersection points between both sections? (if possible?)

See attached picture for more information.

Thanks!

Best regards,
Paul

Title: Re: Intersection point(s) between 2 cross-sections
Post by: Jeff on April 20, 2012, 03:08:26 AM

You can create 2 short vectors by anchoring them to the cross section. Then you can create a point from intersection of 2 vectors. I hope this helps. Jeff

PointCloud.us - A PolyWorks Support Forum

PolyWorks Discussion => Inspector => Topic started by: VDK on April 20, 2012, 01:02:20 AM